Tuesday, 27 March 2012

You can set up your printer on any wireless network if you have a USB cable nearby to use for a
temporary connection. Follow these steps to create a wireless connection to the printer:
1. Get all of the necessary settings for the wireless network..
2. Close any running applications.
3. Insert the Starter CD into the CD drive. The CD menu runs automatically.
If the CD menu does not start automatically, double-click the Setup icon on the Starter CD.
4. On the CD menu, click Install Printer Driver (Windows) or Install Driver (Mac OS).
5. Follow the onscreen instructions to complete the software installation.
a. Enter the wireless network settings in the dialogs.
b. Temporarily connect a USB cable when prompted.
c. Mac OS only: Complete the installation using the HP Deskjet 460 Network Setup Tool, which
launches automatically during setup.
NOTE: When new 802.11 settings are sent to the printer to configure one of the wireless profiles, the
printer will turn off and then back on again (power cycle) to enable the settings.
To configure additional 802.11 wireless profiles after you have set up the printer, see Configuring and

To set up on an existing network with no USB cable
This section describes connecting to an existing network with settings other than the factory defaults, or
setting up a new ad hoc (Windows) or computer to computer (Mac OS) network that does not use the
factory defaults, when all of the following conditions are true:
• You have a computer with 802.11.
• You do not have a USB cable.
• You have never set up the printer to connect wirelessly.
If all of the above are true, then you will need to do the following:
1. Set up the printer with a wireless connection using the factory defaults. See
2. Configure one of the three positions of the wireless profile switch with the desired network settings

kind of any problem Call Us 
+1-855-517-2433(Toll Free)


  1. after reading your blog everything seems so easy.