Tuesday, 27 March 2012

To set up using ad hoc mode and factory defaults with no USB cable (Windows) in Hp Printer

You can set up your printer on a wireless ad hoc network using the default settings even if you have no
USB cable. Follow these steps to connect to the printer using its factory default ad hoc network settings:
1. Open the configuration utility for your computer’s wireless network card, then do the following:
a. Create a new wireless profile with the following values:
• Communication mode: ad hoc
• Network name (SSID): hpsetup
• Security (encryption): disabled
b. Activate the profile.
2. Wait two minutes for the printer to obtain an IP address, then print a wireless configuration page by
holding down (Cancel button) for more than two seconds.
3. On the configuration page, verify the following for the printer’s network settings:
• Communication mode: ad hoc
• Network name (SSID): hpsetup
• The IP address is not

If one of the previous conditions is not true, then repeat the preceding steps.
4. Close any running applications.
5. Insert the Starter CD into the CD drive. The CD menu runs automatically.
If the CD menu does not start automatically, double-click the Setup icon on the Starter CD.
6. On the CD menu, click Install Printer Driver.
7. On the Connection Type screen, select Wireless, and then click Next.
8. Follow the onscreen instructions to complete the software installation.

kind of any problem Call Us 
+1-855-517-2433(Toll Free)

1 comment:

    Printer Technical Support Number
    We are a team of qualified and experienced professionals that aim to provide you with the best service available in the market.